Modified standard
Use an existing family as the baseline, then change voltage, taps, leads, insulation, mounting or enclosure.
- Existing product or drawing
- Required changes
- Quantity and target date
CUSTOM & REPLACEMENT
Start from the requirement you actually have.
Send a drawing, nameplate, failed unit or an incomplete specification. We reconstruct the design constraints, identify missing information and move towards an approved configuration.
New custom design
Define the transformer from the application, source, loads, environment and end-product standard.
- Electrical requirements
- Mechanical envelope
- Compliance route
Nameplate replacement
Start with a label, photo, measurement and application when original drawings or the supplier are absent.
- Nameplate photos
- Installed dimensions
- Failure and load context
REVIEW SEQUENCE
From incomplete information to an approved baseline.
The first response should separate confirmed facts, engineering assumptions and missing data. That protects both the design and the quotation.
- 01Requirement capture
Consolidate drawings, labels, application and quantity.
- 02Engineering questions
Close the values that materially affect the design.
- 03Specification and quote
Issue the proposed rating, drawing route and commercial scope.
- 04Sample and approval
Verify form, fit, function and documentation.
- 05Production control
Release against the approved revision and test plan.
FILE CHECK
Open specification checker
Not sure what is missing?
Use the transformer specification tool to organize the first set of requirements before sending files.
ENGINEERING REVIEWSend the drawing,