Equipment isolation
Common starting point for diagnostic, laboratory and single-phase medical equipment supplies.
Single-phase isolationCustom medical isolation transformers combining a separated secondary, voltage adaptation and project-defined shielding or grounding for medical and laboratory equipment.
A medical isolation transformer creates a separated secondary supply for medical or laboratory equipment. It can also adapt voltage, support a defined grounding arrangement and allow an electrostatic shield when the equipment architecture requires one.
The transformer is one part of a larger safety system. Device classification, patient-connected circuits, leakage current, clearances, protective bonding, overcurrent protection, enclosure and final-product testing remain part of the equipment design.
A transformer supports the device architecture. It does not independently certify the complete medical device, isolated power installation or hospital system.
The separated secondary is the starting point. Power, phase, voltage, shielding, size, insulation and environmental protection determine the actual transformer route.
Common starting point for diagnostic, laboratory and single-phase medical equipment supplies.
Single-phase isolation
For three-phase equipment where phase relationships, balance and coordinated protection also need review.
Three-phase isolation
A round, often low-profile construction for instrument chassis and sensitive electronic systems.
Toroidal route
Enclosure or encapsulation can add mechanical and environmental protection where the thermal route allows it.
Protected designsESTABLE's published medical and instrument examples span 200 VA to 1.5 kVA, with configuration-specific designs extending higher. Do not select the rating or insulation from the “medical” label alone.
The transformer drawing must agree with the equipment's electrical, mechanical and documentation assumptions before production is released.
Final equipment standard, circuit architecture and sensitive or patient-connected parts.
Input, outputs, VA, current, duty, voltage drop, inrush and thermal conditions.
Insulation, screen, ground, leads, terminals, enclosure and installation envelope.
Sample approval, routine-test scope and the configuration covered by supporting records.
The anonymised example separates the component requirement from the complete device conformity route.
A hospital equipment project required a 220 V to 110 V isolated supply, copper-foil shielding and a 4.2 kV dielectric-withstand target. The public case does not claim a verified pass record; the configuration-specific drawing and test evidence remain part of the approval route.
Read the complete project caseDirect answers for equipment engineers, laboratory system designers and procurement teams.
A transformer that provides a separated secondary supply for medical or laboratory equipment and supports voltage adaptation, shielding and a defined grounding route.
It describes the intended application, not an automatic certification. The configuration, surrounding system and evidence must be defined against the equipment requirements.
No. An isolated power system can include monitoring, alarms, distribution and protective equipment beyond the transformer.
Start with connected load and duty, then review starting current, voltage drop, harmonics, ambient and enclosure temperature.
Yes, when required. Screen material, termination and grounding must be defined in the drawing and compatible with the system grounding layout.
No. Compliance applies to the defined product and system scope, so the destination requirements and final equipment must also be assessed.
Yes, when enough electrical, dimensional, connection and nameplate information is available. The replacement still needs a project-specific review.
Device classification, schematic, input and output voltage, VA, load, insulation, leakage, shield, grounding, enclosure and target standard.